PortfolioP&L Railway Bridge design and construction P&L Railway Bridge design and construction Project Summary Hanson was chosen to design a new 3,100-foot-long railroad bridge that will carry rail traffic over the Tennessee River. This project includes approximately 12,500 feet of relocated single-track line involving embankment and cut-slope designs and associated roadway and utility relocations. In addition, the project must accommodate the building of a new lock. Because barges traveling on the Tennessee River often experience traffic jams at the 600-foot Kentucky Lock in western Kentucky, construction is underway to build a new lock that will ensure passage of barges in configurations up to 1,200 feet long — reducing delays on the waterway. Hanson located the railroad bridge approximately 1,500 feet downstream from the existing bridge to allow room for the new lock construction. The new high-level bridge has 17 approach spans and a 500-foot main span over the navigation channel. The approach spans vary between 152 feet and 157 feet. Each approach span consists of a concrete-ballast pan supported by four 10-foot-deep composite steel-plate girders. The structural steel is Grade 50 weathering steel throughout, and the piers for the approach spans consist of a single concrete column supported by either steel piles or concrete drilled shafts. The design standards for this project include American Railway Engineering and Maintenance-of-Way Association (AREMA) specifications and standards furnished by the P&L Railway. In addition to designing the bridge, Hanson supported the Nashville District’s staff in overseeing the bridge construction. Services included preparing a design memorandum, construction plans and specifications and providing construction-phase services for the relocation of the P&L Railway Bridge. Hanson facilitated coordination meetings at the project site. Because the railroad-bridge project involved numerous agencies and governmental entities, along with other consultants, Hanson provided a critical communications/problem-solving link in bringing them together. Float-in construction was used for the railroad-truss main span to minimize obstruction to navigation. Rail traffic was maintained during construction except during the short time needed to realign the rails at each end of the project. The P&L Railway Bridge over Kentucky Highway 282 was built adjacent to the existing structure and rolled into place during the rail-realignment process. Show More Project Images P&L Railway Bridge design and construction This album stores photos for the P&L Railway Bridge design and construction project.